Strong joints are crucial for a lasting saw and only takes a few simple steps:
1. PROTECT. Wear disposable gloves. Follow the manufacturer’s safety guidelines.
2. USE HIGH-QUALITY EPOXY. I use West Systems 105 with 206 and measure each part carefully.
3. MIX PARTS together for 1 minute.
4. EACH SIDE OF THE JOINT. Use as-mixed epoxy so it can seep into the grain.
5. THICKEN REMAINING EPOXY. Mix in West Systems 406 filler until it is the consistency of ketchup.
6. APPLY THICKENED EPOXY. Spread a thin layer to the joints and apply gentle clamping pressure.
7. CLEAN UP. Remove as much squeeze-out as possible before it cures using paper towels and cotton swabs dipped in acetone.
8. CURE. Follow the manufacturer’s instructions.
9. CLEAN OFF THE WAXY RESIDUE. Wipe down using white vinegar.…
You're reading a preview of
Popular Woodworking (Digital) - 1 Issue, September/October 2023